Pro-face AGP-3300 Series Installationsanleitung PDF herunterladen (Seite 9)

9

• Tightening the screws with too much force

can damage the GP unit’s plastic case.

• The necessary torque is 0.5 N•m.

3. Wiring and attaching/detaching

the AUX connector (GP-3400

series only)

• Be sure to remove the AUX Connector from

the GP unit prior to starting wiring. Failure

to do so may cause an electric shock.

 Items Required to Wire Connectors

[Screwdriver]

Recommended type: SDI (Product No.

900837) <Weidmuller Japan>

If another manufacturer is used, be sure

the part has the following dimensions:

point depth: 0.4 mm [0.02 in.]

point height: 2.5 mm [0.10 in.]

length from the point to the handle:

80 mm [3.15 in.]

Point shape should be DIN5264A, and

meet Security Standard DN EN60900.

Also, the screwdriver’s tip should be flat

as indicated in order to access the

narrow hole of the connector:

 Detachment

Turn the tabs on the levers at both ends

of the connector, and the connector is

released from the GP.

 Wiring and attachment

(1) Insert the tip of the screwdriver into

one of the square holes. Then, insert

the cable into the corresponding

round hole. When you pull out the

screwdriver, the cable is locked. For

the pin assignment of the AUX con-

nector, refer to “External Interfaces”.

(2) Insert the wired AUX connector into

the auxiliary I/O or sound output

interface (AUX) on the left side of the

GP unit on. If the connector cannot

be fully inserted, turn the tabs on the

levers at both ends of the connector

in the reverse direction and insert the

connector.

*1 Wire should be AWG 22 to AWG 18 thick, and

twisted.

Applicable wire sizes are UL1015 and UL1007.

*2 Be sure to strip from 6.5 to 8.0 mm [0.26 to

0.31 in.] of cover from the wire.

• Be sure to strip only the amount of

cover required. If too much cover is

removed, the end wires may short

against each other, or against an

electrode, which can create an electric

shock. If not enough cover is removed

the wire cannot carry a charge.

• Do not solder the wire itself. This could

lead to a bad or poor contact.

• Insert each wire completely into its

opening. Failure to do so can lead to a

unit malfunction or short, either against

wire filaments, or against an electrode.

*3 Do not rotate the point of the screwdriver

inside the square-shaped opening. It may

cause a malfunction.

Insertion Slot Recess

Hook the fastener on the

Recess,

Panel

Installation Fastener

GP

Hook

and secure the fastener

on the panel with a screw.

Screwdriver Tip

Shape

Wire

*1 *2

Screwdriver

*3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare