Pro-face FP2600-T41 Installationsanleitung PDF herunterladen (Seite 7)

Pin Assignments and Signal Names for Serial Interface

Serial Interface

Baud rate:9600 bps

Datalength:8 bits

Parity:none

Stop bit:1

Serial Interface

No.

Signal

Name

Condition Pin Location

1CDCarrierDetect(FP->Host)

2 RD Receive D ata(FP->Host)

3SDSendData(FP<-Host)

4DTRDataTerminalR eady (FP<-Host)

5GNDGround

6 DSR DataSetReady(FP->Host)

7 RS RequesttoSend(FP<-Host)

8CSCleartoSend(FP->Host)

9 NC No connection

Concerning Signal Names

Signal names used for the serial interface on FP units are designed to

match the pin order used on most PC serial interfaces, so that a

straight cable can be used to connect the two. Therefore, connect

each pin's signal to the same signal name on the PC side.

For example, pin #2 'RD' should be connected to the 'RD' input

terminal on the PC's connector.

Refer to section "2-4 Cable Diagrams" for each signal's direction.

Connector: Dsub 9 pin female

Connector set screw: Inch type (4-40)

Pin Assignments and Signal Names for USB Interface

Communication Low speed Device

Connector: B type connector

USB Interface

NO.

Signal

Name

Condition Pin Location

1 USB1-5V +5VIN

2 USBD1(-) USBdata(-)

3 USBD1(+) USBdata(+)

4 GND Ground

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

Pro-face FP2600-T41 Installationsanleitung Seite 7